ultra thin ASME Sultra thin ASME SA36 steel sheet Thickness control technology

ASME SA36 steel sheet is popular wing to its widely uses. Every year, there are lot of quantity ASME SA36 steel sheet be exported to other countries from katalor. the technology in produce ASME SA36 steel sheet is high. The bellow is ultra thin ASME SA36 steel sheet Thickness control technology .

In order to get high accuracy of ASME SA36 steel sheets thickness, AGC is an essential technology. There are many ways of AGC. The most commonly used method is to use finishing mill outlet thickness gauge to measure ASME SA36 steel sheets thickness deviation, and to control monitor AGC at the down position of all racks after finishing.

However, when the gain feedback between the frame is not correct, the correction of ASME SA36 steel sheets thickness will focus on a particular frame, and sometimes it can lead to large load changes in order to adapt to the rolling of ultra thin ASME SA36 steel sheets that have very large plastic constant. Based on the measured thickness of each rear rack, the ASME SA36 mild steel sheets thickness deviation is minimized. At the same time, because the absolute value AGC is also used on the front rack of the ASME SA36 steel sheets thickness gauge, the SA36 steel sheets thickness control system of the whole rack can be achieved. Because SA36 carbon steel sheets thickness control system does not focus the correction of plate thickness deviation on a specific frame, it can control ASME SA36 steel sheets with high precision.

25% ASME SA36 steel sheets thickness change is necessary when sheets rolling is from 1.2mm to 0.9mm thick. There is no need to make a great change in the thickness change of ultra-thin hot rolled ASME SA36 steel sheets. For this reason, the best screw down procedure should be set before and after the thickness change. According to the setting result, the position and speed of the whole frame are changed, and the middle ASME SA36 steel plate thickness changing system based on setting calculation is developed.

Any other information of ultra thin ASME SA36 steel sheet Thickness control technology, please  contact katalor!!!

Pre: The introduce of GB/T 1591 Q345D steel plate welding performance

Next: In April, the average daily output of crude steel was 2,556,700 tons, an increase of 7.13% over the